2 Installing the NB Unit and Connecting Peripheral Devices 2-5 UDP Communication Connection 2-5 UDP Communication Connection This section describes how to connect the PT with the Host through the UDP protocol. Note Both OMRON CJ/CS/NJ/NX Series Ethernet UDP and OMRON CP Series Ethernet UDP communication protocols are UDP protocol. The difference between these two protocols is only in the address range of the channel. When using OMRON Ethernet UDP communication protocol, EM4 bank or higher cannot be accessed at bit level. 2-5-1 Connecting to Host Via Ethernet To connect to the network using Ethernet, the network number, node number, and IP address must be set.
Use the NB-Designer to set the settings. (The default IP address of PT Unit is 192.168.250.1.) 2-5-1 Connecting to Host Via Ethernet Connecting PT Directly to the Host Connect the NB to the host using twisted-pair cable. Connecting PT to Host with a Hub Multiple NBs and hosts can be connected using twisted-pair cable and a hub. Hub 10Base-T/100Base-T Twisted-pair cable NB 1 NB2 Host 1 Host 2 The UDP communication for NB series products is only limited the local network, but the Ethernet communication crossing the network segment is allowable with the prerequisite of using the router.
That’s to say, the supported network is only limited to the local network, but the various devices in the network can cross the network segment. Please take the following architecture as reference. NB1 NBx-2 PLC1 PLCy-2 Hub Router Twisted-pair cable 10Base-T/100Base-T PLCy PLCy-1 NBx NBx-1 NB-series Programmable Terminals Setup Manual(V107) 2-27 2 NB Host Twisted-pair cable 10Base-T/100Base-T