2 Installing the NB Unit and Connecting Peripheral Devices X represents the amount of NB series products, and y represents the amount of PLC. The relationship between x and y must meet the following conditions: • x = 1 • y ≥ 1 • x + y ≤ 33 In this system architecture, the system has only one network number. And the unique ID, i.e. Node ID, is assigned to both NB and PLC in the system. When the actual amount of configured devices (NB series products + PLC) is greater than 33, or add another NB, the customer can create a new NB-Designer project to handle this problem. Additional Information UDP communication via Ethernet is convenient as it allows free access to hosts on the network.
In cases where there are many hosts and NB Units connected on a single network, however, response speed of a host may be lowered due to excessive access to the particular host or NB Unit, subsequently leading to possible lowered response speed of the NB Unit which refers to values in the host. Thus, when making a system, please examine the load of the maximum configuration, and design and test the system while fully considering performance. Recommended Network Configuration Devices The following products are recommended for configuring the network when an Ethernet Unit is used.
2-28 NB-series Programmable Terminals Setup Manual(V107) Part Maker Model number Specifications Inquires Hub 100BASE-TX OMRON W4S1-03B 10/100 Mbit/s 3-port switching hub OMRON W4S1-05B(C) 10/100 Mbit/s 5-port switching hub Phoenix Contact SWITCH5TX 10/100 Mbit/s 5-port switching hub Twisted-pair cable 100BASE-TX Fujikura CTP-LAN50.5mm x 4P UTP (unshielded twisted- pair) cable: Category 5, 5e 10BASE-T Fujikura CTP-LAN50.5mm x 4P UTP (unshielded twisted- pair) cable: Category 3, 4, 5, 5e Connectors (Modular plug) UTP Plug Panduit Corp MP588-C ---