2 Installing the NB Unit and Connecting Peripheral Devices 2-5 UDP Communication Connection Precautions on Laying Twisted-pair Cable Basic Precautions • Push the cable connector until it clicks into the place both the PLC and the hub. • After laying the twisted-pair cable, check the connection with a 10Base-T cable tester. Environment Precautions • The UTP cable is not shielded. Also, hub is created for use under OA environment. Construct a system using a hub suitable for use under FA environment in locations subject to noise. • Do not lay the twisted-pair cable together with high-voltage lines. • Do not lay the twisted-pair cable near devices that generate noise.
• Do not lay the twisted-pair cable in locations subject to high temperature or high humidity. • Do not lay the twisted-pair cable in locations subject to excessive dirt and dust or to oil mist or other contaminants. 2-5-1 Connecting to Host Via Ethernet Hub Installation Environment Precautions • Do not install the hub near devices that generate noise. • Do not install the hub in locations subject to high temperature or high humidity. • Do not install the hub in locations subject to excessive dirt and dust or to oil mist or other contaminants. Connecting the Cable Note 1 Turn OFF the PLC’s power supply before connection or disconnecting twisted-pair cable.
2 Allow enough space for the bending radius of the twisted-pair cable. 1 Lay the twisted-pair cable. 2 Connect the cable to the hub. Be sure to press in the cable until it locks into place. Request cable installation from a qualified professional. 3 Connect the cable to the connector on the PLC. Be sure to press in the cable until it locks into place. NB-series Programmable Terminals Setup Manual(V107) 2-29 2