2 Installing the NB Unit and Connecting Peripheral Devices 2-5-2 Parameter Settings for UDP at NB Side After placing the desired PT and PLC into Configuration and Setup Window, select [Communication Setting] in the [Option] menu, and then click the “Add” button after the “Communication Setting” dialog box pops up. After selecting the Device Type and the related UDP protocol, you can make settings of IP Address, Node ID and Network No. and etc. for the PT. Note When there is CP1E PLC in the UDP network architecture, the Network No. should be 0. Otherwise, the communications through the UDP protocol between the NB and CP1E in this architecture will be impossible.
The settings of IP Address, Node ID and related communication parameters for PLC can be made. Note The settings of communication parameters should be the same as that of the actual PLC. 2-30 NB-series Programmable Terminals Setup Manual(V107)