2 Installing the NB Unit and Connecting Peripheral Devices 2-5-3 Host Types and Settings of Ethernet Unit Units that are used for Ethernet communications vary according to the type and series of OMRON PLC used. When connecting an Ethernet Unit, check the series and type of the PLC that it will be connected to and the model of the Unit that is mounted to the PLC. Connecting the Controllers and NB Series Units by the combinations in the table below. For details on the hosts that can be connected to NB-series PTs via the Ethernet, refer to A-5 List of Models. Host Settings The types of hosts that can be connected to NB-series PTs with the Ethernet and the host settings are as follows.
The following settings must be set at the host. Note 1 The max total number of registered nodes by NB-Designer in the network is 33, at least 1 NB-series PT and 1 host included. 2 If there is CP1E PLC in the actual network architecture, the Network No. must be set to 0. 3 The Node ID of 0 is equivalent to that of 1 (default).
2-32 NB-series Programmable Terminals Setup Manual(V107) Series name Using the built-in board Using an Ethernet Unit Ethernet Unit CS Series — CS1G/H-CPU(-V1) CS1W-ETN21 CS1G/H-CPUH CS1D-CPUH CS1W-ETN21 CJ Series — CJ1G/H-CPUH CJ1W-ETN21 CJ1M-CPU(-ETN) CJ1M-CPU-ETN — — — CJ2H-CPU(-EIP) CJ1W-ETN21 CJ2M-CPU CP1H Series — CP1H-Y CJ1W-ETN21 CP1W-CIF41 CP1H-XA CP1H-X CP1L Series — CP1L-L14/20 CP1W-CIF41 CP1L-M30/40/60 CP1L-EL20 — — CP1L-EM30/40 CP1E Series — CP1E-N30/40/60 CP1W-CIF41 CP1E-NA20 CP2E Series CP2E-N14/20/30/40/60 — — Item Host Settings Number of nodes 33 (See note 1) Network number 0 to 127 (See note 2) UDP port number 1024 to 65535, default is 9600.
IP address 0.0.0.0 to 255.255.255.255 Subnet mask 0.0.0.0 to 255.255.255.255 Default gateway 0.0.0.0 to 255.255.255.255 Node number 0 to 254 (See note 3)