2 Installing the NB Unit and Connecting Peripheral Devices Setting Local IP Addresses 2-5 UDP Communication Connection Use a Web browser to set the local IP address of the CP-series Ethernet Option Board. Refer to the following manuals for the setting procedures. CP1H: SYSMAC CP Series CP1H CPU Unit Operation Manual (Cat. No. W450) CP1L: SYSMAC CP Series CP1L CPU Unit Operation Manual (Cat. No. W462) CP1E: SYSMAC CP Series CP1E CPU Unit Software User’s Manual (Cat. No. W480) Ethernet Connector CP1W-CIF41 This is the connector used to connect the twisted-pair cable to the Ethernet. • Electrical Characteristics: Conform to the IEEE 802.3 standard. • Connector Layout:
RJ45 8-pin modular connector (conforms to ISO8877.) 2-5-3 Host Types and Settings of Ethernet Unit Setting Node Numbers Set the node number to a unique value from the CX-Programmer or other Support Software. Do not set it to the same value as any other Ethernet node on the same Ethernet network. Refer to the following manuals for the setting procedures. CP1L-EL/EM: SYSMAC CP Series CP1L-EL/EM CPU Unit Operation Manual (Cat. No. W516) Setting Local IP Addresses Set the local IP address from the CX-Programmer or other Support Software for the CP1L-EL/EM series CPU Unit. Refer to the following manuals for the setting procedures. CP1L-EL/EM:
SYSMAC CP Series CP1L-EL/EM CPU Unit Operation Manual (Cat. No. W516) Ethernet Connector CP1L-ETN21 This is the connector used to connect the twisted-pair cable to the Ethernet. • Electrical Characteristics: Conform to the IEEE 802.3 standard. • Connector Layout: RJ45 8-pin modular connector (conforms to ISO8877.) Setting Node Numbers Set the node number to a unique value from the CX-Programmer or other Support Software. Do not set it to the same value as any other Ethernet node on the same Ethernet network. Refer to the following manuals for the setting procedures. CP2E-N: SYSMAC CP Series CP2E CPU Unit Software USER’S MANUAL (Cat. No.
W614) Setting Local IP Addresses Set the local IP address from the CX-Programmer or other Support Software for the CP2E-N series CPU Unit. Refer to the following manuals for the setting procedures. CP2E-N: SYSMAC CP Series CP2E CPU Unit Software USER’S MANUAL (Cat. No. W614) Ethernet Connector CP2E-N14/N20/N30/N40/N60 Built-in Ethernet Port This is the connector used to connect the twisted-pair cable to the Ethernet. • Electrical Characteristics: Conform to the IEEE 802.3 standard. • Connector Layout: RJ45 8-pin modular connector (conforms to ISO8877.) NB-series Programmable Terminals Setup Manual(V107) 2-37 2 CP1L-EL/EM CP2E-N