2 Installing the NB Unit and Connecting Peripheral Devices 2-5-4 Host Types and Settings of Ethernet/IP Unit NB-series enables communication with a controller via the Ethernet using built-in ports of the controller or EtherNet/IP Unit. Units that are used for communications vary according to the type and series of OMRON PLC used. When connecting an Ethernet/IP Unit, check the series and type of the PLC that it will be connected to and the model of the Unit that is mounted to the PLC. NB-series PTs and the following Controllers can be connected with Ethernet/IP units. Note 1 Ethernet/IP Unit:
Unit version 2.1 or later, the CJ2H-CPU -EIP and CJ2M-CPU3 CPU Units have a built-in Ethernet connector. 2 Use Port 2 to communicate via a built-in EtherNet/IP port of NX102. For details on the hosts that can be connected to NB-series PTs via the EtherNet/IP, refer to A-5 List of Models . Refer to the following manual for host parameter settings: SYSMAC CS/CJ-series Ethernet/IP Units Operation Manual (Cat. No. W465), SYSMAC CJ-series CJ2 CPU Units Operation Manual (Cat. No. W472). For the limitations to the Host parameters’ setting, refer to 2-5-5 Parameter Settings at Host Side (CX- Programmer) .
Refer to the following manual for the setting methods of each parameter, when connecting an NJ/NX- series CPU Unit: NJ/NX Series CPU Unit Built-in EtherNet/IP Port User’s Manual (Cat. No. W506) There are limitations on the parameters’ setting. Refer to 2-5-6 Parameter Settings at Host Side (Sysmac Studio) for details.
2-38 NB-series Programmable Terminals Setup Manual(V107) Series name Using the built-in board Using an EtherNet/IP Unit EtherNet/IP Unit CS Series — CS1G/H-CPU(-V1) CS1G/H-CPUH CS1D-CPUH CS1W-EIP21 CJ Series — CJ1G/H-CPUH CJ1M-CPU(-ETN) CJ1W-EIP21 CJ2H-CPU-EIP — — CJ2M-CPU3 — — — CJ2H-CPU(-EIP) CJ2M-CPU CJ1W-EIP21 CP Series — CP1H CJ1W-EIP21 NJ Series NJ501 NJ301 NJ101 — — NX Series NX102 NX1P2 — —