2 Installing the NB Unit and Connecting Peripheral Devices Ethernet Connectors This is the connector used to connect the twisted-pair cable to the Ethernet. • Electrical Characteristics: Conforms to IEEE802.3 standards. • Connector Layout: RJ45 8-pin modular connector (conforms to ISO 8877). 1 8 NJ-series CPU Unit (Built-in EtherNet/IP Port) NJ501 NJ301 NJ101 NX-series CPU Unit (Built-in EtherNet/IP Port) NX102 *1 NX1P2 *1 Use Port 2 to communicate via a built-in EtherNet/IP port of NX102. Setting IP Addresses Set the IP address of the NJ/NX unit with the Sysmac Studio. Refer to the Sysmac Studio Version 1 Operation Manual (Cat. No.
W504) and the NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (Cat. No. W501) for details on setting methods. Ethernet Connectors This is the connector used to connect the twisted-pair cable to the Ethernet. • Electrical Characteristics: Conforms to IEEE802.3 standards. • Connector Layout: RJ45 8-pin modular connector (conforms to ISO 8877). 1 8 • Memory Settings for CJ-series Units Refer to the description of " When connecting to a NX Series Serial Communication Board" in 2-4- 3 Settings for each Unit.
2-40 NB-series Programmable Terminals Setup Manual(V107) Connector Pin Signal name Abbreviation Signal direction 1 Send data + TD+ Output 2 Send data - TD- Output 3 Receive data + RD+ Input 4 Not used. - - 5 Not used. - - 6 Receive data - RD- Input 7 Not used. - - 8 Not used. - - Connecting to a NJ/NX-series CPU Unit Connector Pin Signal name Abbreviation Signal direction 1 Send data TD+ Output 2 Send data - TD- Output 3 Receive data + RD+ Input 4 Not used. - - 5 Not used. - - 6 Receive data - RD- Input 7 Not used. - - 8 Not used. - -