2 Installing the NB Unit and Connecting Peripheral Devices The limitations are as follows: 2-5 UDP Communication Connection 1. Select the “Convert” in the [Dynamically change remote IP] setting. 2. Set the IP address in the [IP Address Table] when either the “IP address” or “Combination” is selected in the [IP address-FINS address conversion method] setting and do not set the Node ID of NB into it. *1 *1 If the Node ID of NB is placed into the [IP address Table], the system will require the NB to use the same port with the PLC, and “PLC response error” information will appear on NB.
The prompts for possible errors occurred to NB when OMRON CJ/CS/NJ Series or NX1 Series Ethernet UDP driver is adopted are described as follows. “PLC Response Error”: Response to the abnormal information caused by the Read/Write command to PLC. “PLC No Response: xx-xx-x”: No response is made by PLC and xx-xx-x represents PT No.-Node ID of PLC-Port Number. 2-5-6 Parameter Settings at Host Side (Sysmac Studio) NB-series Programmable Terminals Setup Manual(V107) 2-45 2