Appendices The cable for connecting the NB5Q/NB7W/NB10W Unit serial port COM2 to OMRON PLC (RS-422A) COM2 (female) at the NB Unit side NB Unit side OMRON PLC side 1 6 A-4 Fabrication of the Connection Cable A-4-4 Method for Fabricating the Cable for Connection to OMRON PLC 5 9 Shielded Cable Note If the RS-485 connection is adopted, make sure to short the terminating resistances, and then connect only Pins No. 6 and No. 8 and the shielded cables to the corresponding pins on the PLC side.
The cable for connecting the NB5Q/NB7W/NB10W Unit serial port COM2 to OMRON NX1W-CIF11/CIF12 (RS-422A) COM2 (female) at the NB Unit side NB Unit side NX1W-CIF11/-CIF12 RS-422A/485 terminal block 1 6 RDA- RDB+ SDA- SDB+ SHLD RDA- RDB+ SDA- SDB+ SHLD COMM 5 9 Shielded Cable Operation setting DIP switches on the back of the NX1W-CIF11/CIF12 Option Board For an NX1W-CIF11 For an NX1W-CIF12 SW1 SW1 SW2 O N 1 2 3 4 5 6 O N O N 1 2 O N O N 1 2 O N SW1 SW1 SW2 1 2 3 4 1 2 3 4 NB-series Programmable Terminals Setup Manual(V107) A-13 Signal Name Pin No. SDB+ 1 SD(TXD) 2 RD(RXD) 3 Terminal 1 4 Terminal 2 5 RDB+ 6 SDA- 7 RDA- 8 SG 9 FG Connector Hood Pin No.
S ignal Name 1 RDA- 2 RDB+ 3 SDA- 4 SDB+ 5 FG Signal Name SDB+ SD(TXD) RD(RXD) Terminal 1 Terminal 2 5 RDB+ SDA- RDA- SG FG App 1 2 3 4 5 6