Appendices A-4-5 Method for fabricating the cable for connection to PC When fabricating the cable for connecting with NB-Designer, refer to the following methods: Depending on the type of the RS-232C connector compatible with PCs according to DOS/V, deploy the wiring as shown below:
25-pin Connector COM1 (female) at the NB Unit side NB Unit side Shielded Cable DB25 Serial Port at the PC side RS232 DB25 (male) at the PC side 1 6 13 25 5 9 14 1 9-pin Connector COM1 (female) at the NB Unit side NB Unit side Shielded Cable DB9 Serial Port at the PC side RS232 DB9 (male) at the PC side 1 6 5 9 5 9 1 6 Note As to the 2 connection methods introduced above, the No.2, 3 and 9 pins of COM1 on the NB3Q unit side have the same definitions as those described in the above diagram, and the method for connection to a PC is also the same as above. A-14 NB-series Programmable Terminals Setup Manual(V107) Signal Name Pin No.
FG Connector Hood NC 1 SD 2 RD 3 RS (RTS) 4 CS (CTS) 5 DC+5V 6 NC 7 NC 8 SG 9 Pin No. Signal Name Connector Hood FG 1 FG 2 SD 3 RD 4 RS 5 CS 6 DR 7 SG 8 CD 20 ER 22 RI Signal Name Pin No. FG Connector Hood NC 1 SD 2 RD 3 RS (RTS) 4 CS (CTS) 5 DC+5V 6 NC 7 NC 8 SG 9 Pin No. Signal Name Connector Hood FG 1 CD 2 RD 3 SD 4 ER 5 SG 6 DR 7 RS 8 CS 9 RI