Nucleo GX Manual 7. Internet connectivity Connect the Nucleo GX to the internet to access the full functionality of the VRM Portal . The NGX collects data from all connected products and sends it to the VRM Portal, where you can view the current status of connected products, configure email alarms and download data in CSV and Excel formats. To monitor your system from a smartphone or tablet, download the VRM App for iOS or Android . In addition to remote monitoring, an active internet connection allows the NGX to regularly check for firmware updates. Depending on your settings, updates can be downloaded and installed automatically. Note: IPv6 is supported via automatic configuration.
Manual IPv6 configuration is not available. Internet connection options You can connect the NGX to the internet using any of the following methods: Ethernet: Connect a network cable between your router and the NGX Ethernet LAN port. Built-in WiFi: Connect wirelessly to a router using the internal WiFi module. Mobile network: Use a GX LTE 4G - a cellular USB modem , or connect through a mobile router. USB tethering: Share a mobile phone’s internet connection via USB. Watch this video for guidance on connecting via LAN, WiFi, or GX GSM (also applies to GX LTE 4G): 7.1.
Ethernet LAN port Page 70 Internet connectivity When you connect an ethernet cable between a router and NGX, the Settings → Connectivity → Ethernet page of your NGX will confirm connection. Before connecting the ethernet cable, be very careful not to confuse the GX device Ethernet port with the VE.Bus or VE.Can/ BMS-Can ports!