TwinCAT NC Axes Parameters of the rapid/creep axes Numerical Control (NC) Basics 16 Version: 1.2 Parameter Description Creep distance positive direction The creep distance in the positive direction gives the distance to the target position, below which the velocity changes from rapid to creep velocity, if the direction of travel is positive. If a looping distance is selected then this distance is based on the movement reversal point. This distance is denoted by Δp in positioning example 1 [} 18].
1 Creep distance negative direction The creep distance in the negative direction gives the distance to the target position, below which the velocity changes from rapid to creep velocity, if the direction of travel is negative. If a looping distance is selected then this distance is based on the movement reversal point. Braking distance positive direction The braking distance in the positive direction gives the distance to the target position, below which the creep velocity is switched off, if the direction of travel is positive.
This distance is denoted by Δp in positioning example 1 [} 18] 2 Braking distance negative direction The braking distance in the negative direction gives the distance to the target position, below which the creep velocity is switched off, if the direction of travel is negative. Brake incidence delay time in pos. direction This delay time gives the start-up delay of the brakes after switching off of the creep velocity, if the direction of travel is positive. In positioning example 1 [} 18], this time is between the times T and T .
4 5 Brake incidence delay time in negative direction This delay time gives the start-up delay of the brakes after switching off of the creep velocity, if the direction of travel is negative. Rapid to creep velocity delay time This waiting time is between the switching off of the rapid velocity and switching on of the creep velocity. In positioning example 1 [} 18] , this time is between the times T and T . 2 3