TwinCAT NC Axes Numerical Control (NC) Basics 17 Version: 1.2 Parameter Description Creep distance for stop The creep distance for stop gives the distance that is covered with the creep velocity after calling up the stop. This creep distance is usually selected shorter than the creep distances in positive and negative direction, since the axis should stop as soon as possible and the exact positioning is not a priority. This distance is denoted by Δp in positioning example 3 [} 20]. 1 Brake release delay The brake is released immediately the axis is started and after elapse of the brake release delay either the rapid or creep velocity is activated depending on the displacement.
In positioning example 1 [} 18] , this time is between the times T and T . 0 1 Pulse time in positive direction This parameter is not evaluated and therefore has no effect. Pulse time in negative direction This parameter is not evaluated and therefore has no effect. Parameter Description OPERATION MODE: looping distance The looping distance can be activated with this flag. The looping distance is for approaching the target position always from the same direction. In the case of a positive (negative) looping distance a target position in the positive (negative) direction is increased by the amount of the looping distance and the target then approached from the opposite direction.
Consequently the target position in case of a positive looping distance is always approached with negative velocity and a negative looping distance with positive velocity. Looping distance (+ / -) The looping distance gives the distance, by which the target position is exceeded if necessary so that it is possible to move to the target position from the required direction. This distance is denoted by creep distance (looping distance) in positioning example 2 [} 19]