TwinCAT NC Axes Diagram 1: Dependency of relative torque (M/Mmax) on drift angle. The angle details relate to a complete pulse cycle. The area displayed represents 3.6 degrees on the motor shaft for a motor with 200 pulses at full stepping operation. If the motor has to provide torque when stopped or moving, then the rotor is pushed away from the torque- free ideal position by a corresponding angle. This corresponds to the relationship of a non-linear spring in the drive train. Apart from the resulting position deviation of the driven machine part this is unproblematic if the upper and lower vertex are not reached.
In this case the motor torque drops, and the remaining load torque continues to push the motor. The motor is then not able to return to the correct angel and runs through a complete polling cycle. Only then is there a chance that the magnetic fields from rotor and stator interlock solidly. However, this only leads to a stable relationship if the load moment now is significantly below the motor torque. In this case the motor has then moved by complete cycle and must be re-referenced. However, this situation is not recognizable without appropriate sensors. A totally different situation occurs if the load torque does not go down almost immediately due to the polling cycle shift.
This is usually the case if the load torque results from the acceleration. Now the motor does not engage at the next stable point with a polling cycle shift, but rather runs through these points. It loses more and more speed in comparison with the distinct stator field and runs through each further pulse cycle without creating a net torque. This means that the motor coasts down due to excessively high noise development. At the end the travel profile runs through an area of decreasing pulse frequencies. Depending on the load moment the motor is rapidly accelerated just before the end of the profile and follow the rest of the profile.
Finally, it has not made most of the profile and hence the route. This is also not recognizable without appropriate sensors. When designing a stepper motor particular attention is to be given to fact that the speed has a strong influence on the available torque. The diagram below shows the relationship for a typical motor. Numerical Control (NC) Basics 22 Version: 1.2