TwinCAT NC Axes Diagram 2: Dependency of torque (Nm) on speed (RPM) for a typical stepper motor. Apart from the load torque the motor also has to achieve the torque from the processes that result from the dynamics of the travel profile. If the total torque as shown in the example marked in red is 0.3 Nm then this motor may be run with a max speed of 1200 RPM. In practice however it is essential to plan in a suitable torque reserve. Configuration of the stepper motor axis Axis type: 'Continuous axis (incl. SERCOS)' Encoder type: 'Encoder on KL5051/KL2502-30K/KL2521' Controller type: e.g. 'position controller P' Drive type:
'Drive on KL4XXX/KL2502-30K/KL2521' Referencing As usual, the digital referencing cam signal must be mirrored into the axis interface to the NC (PlcToNc axis structure) via the PLC. The usual procedure for referencing an axis applies, but the hardware feature "latching of a position", initiated by a sync impulse, is not available. Instead, the falling edge is used as local event for determining a reference position during ramp-down from the referencing cam. The accuracy of the referencing process can be increased as required through a reduction in velocity during ramp-down from the cam (the maximum possible precision is one motor step).
In comparison with the axis with analog set value output e.g. via a KL4032 the operation of a stepper motor power section on a KL2502-0010 or -3020 or KL2521 the terminal has to be parameterised depending on the application. Parameterization of the KL2502-0010 or -3020 These versions of the KL2502 have different hardware from the basic one. The resulting increase of all internal working frequencies makes an expanded work area accessible. However this is not taken into account in the KS2000 software at present. Numerical Control (NC) Basics 23 Version: 1.2