TwinCAT NC Axis components Interface Every drive that does not belong to a simulated axis must be associated with a set value output module [ } 41] . Drive types M2400-DAC1, M2400-DAC2, M2400-DAC3, M2400-Dac4, KL4XXX and PWM Terminal KL2502_30K (frq. cnt. pulse mode) and KL4132 (16 bit) (see KL5051), KL4XXX-NONLINEAR, new analog type for non linear curves, TWOSPEED, STEPPER, SERCOS, KL5051, BISSI drive KL5051 with 32 bits (see KL4XXX), AX2000, incremental with 32 bits (AX2000), SIMO611U, incremental with 32 bits, UNIVERSAL, variable bit mask (max. 32 bits, signed value), CBACKPLANE, variable bit mask (max. 32 bit, signed value).
Drive parameters Analog drive Analog does not mean here that the speed is represented by a voltage (e.g. ±10 V) or current (e.g. ±20 mA), but rather that the axis can be adjusted over an effectively continuous range of values. This is of course also possible for drives with digital interfaces such as the BISSI Terminals of type KL5051. Here a speed, which can be adjusted as an analog value, is transported in the form of digital information. Analog parameters Stepper motors See: "Low Cost" stepper motor axis with digital control (24V / 2A) [ } 21] Numerical Control (NC) Basics 35 Version: 1.2 Parameter Data type Description DRIVE-Mode ENUM reserved.
Invert Motor Polarity BOOL Direction of motor rotation is inverted. FALSE = in response to positive drive the axis moves in the direction of larger positions. TRUE = in response to positive drive the axis moves in the direction of smaller positions. Minimum Drive Output Limitation float Lower control limit. The output to the drive is limited to this minimum value. Maximum Drive Output Limitation float Upper control limit. The output to the drive is limited to this maximum value. Parameter Data type Description Reference velocity float The reference velocity for the axis.
When generating the setpoints for the axis, the pre-control assumes that the axis will react by moving at this velocity when driven with the reference output value. Reference output float See above. Drift compensation float This value is added to the drive control level. In this way, a constant offset can be added to the output, in order to compensate, for instance, for zero errors in analog drives.