Axis commissioning 6. On the dynamic tab of the axis set a provisional value of about 200 mm/sІ for the acceleration and deceleration and a jerk of 500 mm/sі. If these values do not allow the constant speed to be reached within the space available, increase the values while retaining the relationship. 7. Now use the and keys in the online image of the axis to start in the "smaller" and "larger" directions, and observe the arithmetic sign of the total output and the controller output. 8. If the two values have the same sign, the axis is reacting with a lower speed than that expected by the feed forward. In this case, the reference speed should be reduced.
If the arithmetic signs are opposed, the axis is moving faster than expected by the feed forward. In that case, the reference speed should be increased. 9. If the controller output is significantly less than 10% of the total output, the maximum manual speed can be increased in steps up to about 50% of the maximum speed. The test movements should be continued using the and keys. 10. If the feed forward is well adjusted, the controller output should represent less than 1% of the total output. Poor mechanical conditions, however, often do not permit such accurate adjustment. Drive parameter: Drift compensation This adjustment is only possible if the drive has an analog tab.
If the set values are provided in analog form, there can often be a voltage difference between the controller and the power section. This can be the result of a real voltage drop. However the cause is nearly always that the zero adjustment of the two sides is not the same. In this case, when the position control is switched off, the axis will slowly leave its position: it drifts. Active position control will stop it not far from the set position. Nevertheless there is then a certain amount of following error. It is possible in this case to compensate for the offset by means of a constant speed offset. However the DAC resolution of a few mV has a negative effect here.
As an alternative, some controllers offer a facility for automatic offset correction. The drive parameter: output limiting It is necessary in some cases to limit the control level output given with a drive to the power section. You will find appropriate input facilities on the drive's global tab. You should, however, only make these adjustments at the end of the axis commissioning. Until that time, the values of –1.0 and +1.0 should be entered for the minimum and maximum limits. Otherwise, the measurements described here will be affected. 6.4 Position control and reduction of the following error Determination and setting the most important position control parameters:
Kv factor and parameters for reduction of the following error. Interface The position controller parameters are accessed via the System Manager. Weighting of the feed forward Axes are usually operated under TwinCAT with a feed forward weighting of 1.0 . In unusual cases it may be necessary to vary this setting. This can be the case if the axis is subject to a highly non-linear relationship between control and velocity. A hydraulic valve whose characteristic curve has a sharp knee would be an example. In such a case the weighting should be reduced until the axis no longer demonstrates excessive advance.
In these cases it is generally necessary to use more complex controller types including an I- component in order to achieve acceptable positioning behaviour. Numerical Control (NC) Basics 62 Version: 1.2