beckhoff TwinCAT 2 — 2 Overview

Overview 2 Overview TwinCAT NC combines function groups that serve to control and regulate axes or synchronized axis groups. An NC task consists of one or more channels of type PTP channel, FIFO channel or NCI channel, and their subsidiary parts. Immediately after start-up the NC axes generally find themselves in one or more PTP channels. If necessary they are then moved to a different channel through a process of reconfiguration. Safety functions You should make yourself aware of the TwinCAT safety functions before commissioning any axes. See: Safety functions [ } 10] Interfaces:

System Manager and PLC The insertion of an NC task, the configuration of the NC channels and the axes, and the use of most of the functionalities is described in the NC section of the System Manager , and in the following libraries: the NC Configuration Library , the NC Library and the NCI Interpreter Library . Hardware I/O There are input/output [ } 41] connections for channels, axes, encoders and drives. NC-PLC-Interface The NC-PLC interface is a cyclic interface, with which on the one hand the PLC channel and axis data can be read and on the other hand the NC channel and axis parameters can be set. Axes TwinCAT supports a variety of axis types:

servo axes, rapid/creep axes [ } 14] , stepper motor axes [ } 21] , "low-cost" stepper motor axes [ } 26] , encoder axes and simulation axes. Axis components Each axis consists of various elements, depending on the axis type. These elements include the encoder [ } 31] , the drive [ } 34] , the controller [ } 36] and the setpoint generator [ } 40] , along with the PLC interface [ } 41] . There are also more complex axes consisting of a number of encoders, switchable controllers or changing setpoint generators.

Axis commissioning Axis commissioning includes knowledge and use of the NC safety functions, application of the necessary safety precautions, observation of a specific sequence of commissioning steps for the axis elements (encoder, drive and controller) and setting the axis parameters. See: Axis commissioning > Overview [ } 57] Safety functions [ } 10] PTP PTP (Point To Point) axis functionality is a control process for one-dimensional positioning of axes, in particular of servo axes. One-dimensional does not necessarily mean linear. It simply means that one component is interpolated in some specified coordinate system (Cartesian coordinates, polar coordinates).

PTP forms the basis of the whole of TwinCAT NC, because at system startup the axes are normally in PTP mode, and are thus position controlled. The extended TwinCAT NC functionalities are achieved on the basis of the PTP modes by reconfiguration (FIFO, NCI) or by coupling (all slave types). Numerical Control (NC) Basics 8 Version: 1.2