3 Implementation Example of Static Pick-and-place Equipment After this screen is closed, the lower part of the toolbar in the main window turns yellow-green. 3-3-7 Teaching Positions This section describes the procedure to use the simulation function of the Sysmac Studio for teaching the positions. The target of teaching in this equipment model is the wait position of the robot and the pick-up and place positions of the workpiece. Robot wait position Robot wait position Robot wait position Workpiece place position Workpiece place position Workpiece place position Conveyor B: static state Workpiece pick-up position Workpiece pick-up position Workpiece pick-up position Conveyor A:
static state You can operate the robot during the simulation in either of the following two ways. Select one of the following depending on the positioning accuracy required for operation and movement. • Manipulate the tool center point of the robot with the mouse in the 3D Visualizer • Manipulate each axis of the robot in V+ Jog Control pane Additional Information • To move the robot to its approximate position, it is convenient to use the mouse and move the tool center point of the robot on the 3D Visualizer. • To move the robot precisely to its correct position, manipulate each axis of the robot in the V+ Jog Control pane 3-66 NJ-series Robot Integrated System Startup Guide (O049)