omron — 4-3-1 Creating a Project File

4 Implementation Example of Dynamic Pick-and-place Equipment 4-3 Programming and Simulation Proce- dures 4-3 Programming and Simulation Procedures This section describes the procedure for creating project files, programing, and setting and checking operation in simulation. The simulation function allows you to check the equipment operation before purchasing actual equip- ment. 4-3-1 Creating a Project File Create a project in the Sysmac Studio. 1 Start the Sysmac Studio and click New Project in the Start page. 4 4-3-1 Creating a Project File The Project Properties dialog box is displayed.

2 In the Project Properties dialog box, enter the Project name , Author , and Comment , and select the Category , Device , and Version as shown in the figure below. 3 Select the Open in Emulation Mode check box, and click the Create button. 4-15 NJ-series Robot Integrated System Startup Guide (O049)