• Check that only one application is using the infrared port. • Make sure the infrared light path is not blocked. Sound Problems If sounds aren’t audible • Check that the volume is not muted. Pressing Fn+F7 toggles muting on and off. • Check the playback or recording sound levels, channels, and muting. See "To adjust the speaker volume." • Press Fn+UP-ARROW several times to make sure the volume isn’t set too low. Display Problems If the display works improperly • Check whether the display resolution is set to its default setting, 1024 x 768 (XGA). Check this is in Start, Settings, Control Panel, Display, Settings. • Try changing the display resolution to the standard VGA option.
If the screen is off or difficult to read • Press Fn+F1 or Fn+F2 to adjust the display. • If the OmniBook is cold, allow it to warm up. • Press Fn+F5 in case the internal display was disabled. (Do this three times to return to the state you started from.) If the display scrolls when the pointer reaches the edge • A high-resolution display setting is active. You can use a high-resolution external display and turn off the OmniBook display by pressing Fn+F5, or you can choose the default OmniBook display setting.
Power Problems If you have power problems that interfere with turning on or starting the OmniBook, see the troubleshooting chapter in the OmniBook Reference Guide , which came with the OmniBook. If the battery runs down too fast • Try conserving power using any of the suggestions listed under “To save battery power” • If the operating time has gotten shorter and the battery is more than a year or two old, you may need a new battery. If the OmniBook is beeping continuously • Battery power is probably extremely low. Plug in the ac adapter or insert a secondary battery. 51