Audio Problems If sounds aren’t audible • Check that the volume is not muted. Press the mute button on the right side of the OmniBook. • Press Fn+UP-ARROW to increase the volume. • Check settings in BIOS Setup. 1. From the Start menu, shut down, then restart the OmniBook. 2. When you see the HP logo, press F2 to enter the BIOS Setup utility. 3. From the System Devices menu, check that Audio is enabled. If you hear a loud high-pitched whine (feedback) from the speakers • Try reducing the Master volume (Start, Programs, Accessories, Multimedia, Volume Control). • Avoid using both the built-in microphone and the built-in speakers.
If sound doesn’t record • Check settings in the BIOS Setup utility. 1. From the Start menu, shut down, then restart the OmniBook. 2. When you see the HP logo, press F2 to enter the BIOS Setup utility. 3. From the System Devices menu, check that Audio is enabled. • Check software controls for recording sound (click Start, Program, Accessories, Multimedia, Sound Recorder). Display Problems If the OmniBook is on, but the screen is blank • Press the space bar to see if the computer is in Standby mode. • Press Fn+F1 or Fn+F2 to adjust the display. • Press Fn+F5 in case the internal display was disabled.
(Do this three times to return to the state you started from.) • If the OmniBook is cold, allow it to warm up. If the screen is difficult to read • Check whether the display resolution is set to its default setting, 1024 Ч 768 (XGA). Check this in Start, Settings, Control Panel, Display, Settings. • Check brightness (Fn+F2 to increase brightness). Hard Disk Drive Problems If the OmniBook’s hard drive doesn’t spin 39