• Check the power source. • Remove and reinsert the hard drive. If necessary, see the OmniBook Reference Guide for instructions. If the hard disk makes buzzing or whining noise • Back up the drive immediately. • Check for alternate noise sources, such as the fan or a PC Card drive. If files are corrupted • Run the McAfee VirusScan program; see "To install McAfee VirusScan." • Windows 95 only. Run the Scandisk surface scan to check the platter. (This is not available in Windows NT 4.0). From the Start menu, click Programs, Accessories, System Tools, Scandisk. Infrared Problems If you have problems with infrared communications • Windows NT 4.0 does not support infrared devices.
• Make sure the infrared light path is not blocked. • Check settings in the BIOS Setup utility. 1. From the Start menu, shut down, then restart the OmniBook. 2. When you see the HP logo, press F2 to enter the BIOS Setup utility. 3. From the System Devices menu, check that Infrared Port is enabled. 4. Press F10 to Save and Exit the BIOS Setup utility. • For infrared communications, an infrared driver must be installed and a BIOS Setup setting must be enabled. For details, refer to the driver's Readme file located in \OmniBook\drivers. • Check that only one application is using the infrared port. • Standard IrDA and fast-IrDA are incompatible (they use different drivers).
• For fast-IrDA, check for DMA conflict with ECP parallel port. • Remove any PC Cards. An infrared IRQ conflict is possible if two PC Cards are plugged in at the same time. If an infrared printer doesn’t print • Make sure the infrared light path is not blocked. • An infrared driver must be installed and the BIOS Setup setting must be enabled. For details, refer to the driver's Readme file located in \OmniBook\drivers. • In Windows Help, use the Print Troubleshooter. Keyboard and Pointing Device Problems 40