If the embedded numeric keypad doesn’t work • Make sure Num Lock is on. • Make sure the embedded Keypad Lock (Fn+F8) is on—or that you press and hold the Fn key to temporarily access the embedded keypad. If the pointer is difficult to control • To customize all pointing devices, use the Mouse icon in Control Panel to go to Mouse Properties. • To customize the operation of the pointing stick, use the pointing stick icon available on the taskbar (or in the Windows Control panel) to access TrackPoint Properties. If the touch pad or pointing stick doesn’t work • Make sure the touch pad or pointing stick is enabled in the BIOS Setup utility. 1.
From the Start menu, shut down, then restart the OmniBook. 2. When you see the HP logo, press F2 to enter the BIOS Setup utility. 3. From the System Devices menu, check Internal Pointing Devices. 4. Select the desired pointing device. 5. Press F10 to Save and Exit the BIOS Setup utility. • Reset the OmniBook. Memory Problems If a message says you are out of memory • In Windows Help, use the memory troubleshooter. • If you are having memory problems running MS-DOS programs, in Windows Help use the MS-DOS troubleshooter. PC Card (PCMCIA) Problems If the OmniBook doesn’t recognize a PC Card • Windows NT 4.0. Make sure the Card Executive is installed. • Remove and reinsert the PC Card.
• If the card requires an IRQ, check that there is one available. • If you’re using Windows 95, look in Device Manager, Properties, Interrupt Request (IRQ). • If you’re using Windows NT, click Start, Programs, Administrative Tools, Windows NT Diagnostics. • Check the OmniBook website for information about supported PC Cards. • Try the card in another computer. • Reset the OmniBook. 41