For most printing problems, use the Print Troubleshooter in Windows Help. If a serial or parallel printer doesn’t print • Check that you are using a proper cable or cable adapter, and that the printer is on. • Check for paper in the printer or other printer errors. • Make sure the printer cable is secure at both ends. If an infrared printer doesn’t print • Windows NT 4.0 does not support infrared devices. • Make sure the infrared light path is not blocked. • Check for paper in the printer or other printer errors. • Make sure Windows is running—infrared printing is supported only while Windows is running. • An infrared driver must be installed and the BIOS Setup setting must be enabled.
For details, refer to the driver's Readme file (located in \Omnibook\Drivers). • In Windows Help, use the Print Troubleshooter. If the left edge of printed output is missing • If the printer you are using is a 600-dpi (dots per inch) printer, try selecting a compatible printer driver for a 300-dpi printer. For example, for a 600-dpi HP LaserJet printer, try using the HP LaserJet IIIsi driver (300-dpi). Certain applications may not work properly with 600-dpi printers. Serial, Parallel, and USB Problems If the serial mouse doesn’t work • First, confirm that you have followed the manufacturer’s installation instructions completely and have installed the mouse properly.
• Check the port connection (may be loose). • Check settings in Control Panel (and in Windows NT Diagnostics). If a serial modem doesn’t work properly • In Windows Help use the modem troubleshooter. • Check the port connection (may be loose). • Check settings in Control Panel (and in Windows NT Diagnostics). If an I/O card stops communicating properly • It may have been reset if the OmniBook suspended or turned off. Exit and restart the application. • Check settings in Control Panel (and in Windows NT Diagnostics). 44