Introduction e) Make sure that you leave Remote Agent running on the target device. 4. Use the Remote Management tool to connect to the target device: a) Run the project development application on your computer. b) On the Home tab of the ribbon, in the Remote Management group, click Connect . The Remote Management dialog box is displayed. c) Select the appropriate connection type for the target device: Network IP , Serial Port , or Microsoft ActiveSync . If you select Network IP , also type the IP address of the target device. If you select Serial Port , also select the COM port and verify the advanced serial communication settings. d) Click Connect .
If you are successfully connected, the connection status is shown in the Status box and the target device's specifications are shown in the Platform box. If you are not connected, check both the connection settings and the physical connections. In particular, if you have selected Network IP as the connection type, check to make sure that port 4322 is open on any firewalls between your computer and the target station, including on the target station itself. Note: In some cases, the Remote Management tool may not be able to connect via Microsoft ActiveSync to a device running Windows CE 6.0 or later. This is because of a problem in the default configuration of Windows CE 6.0. You Page 25