Orion-Tr Smart DC-DC Charger Non-Isolated 7.6. Bluetooth connection issues with VictronConnect In normal operation, the blue Bluetooth LED blinks every 0.8 seconds when the Orion-Tr Smart DC-DC Charger is advertising and available for connection in VictronConnect. See the LED Indicators [14] section for the meaning of the different LED codes. If the Bluetooth LED is not blinking, check the following. Page 23 Troubleshooting & Support Blue LED status LED duration Action to take Off - • No input voltage: The Bluetooth controller is powered by the battery connected to the input terminals. Restore the battery supply. • Bluetooth disabled: Bluetooth was set to Disabled in VictronConnect.
This setting is permanent and cannot be undone. For more details see the Product Information [30] section. • Enabled for 30 seconds selected: Bluetooth is enabled for 30 seconds after power up. After 30 seconds, Bluetooth turns off until the next power up. Repower the unit (disconnect and reconnect the battery input cable) and connect with VictronConnect within 30 seconds. For more details see the Product Information [30] section. If none of the above applies, the unit may be faulty. Submit a warranty claim. Blinking Every 0.8 seconds • A Bluetooth connection may already be active. Only one phone or tablet can connect at a time.
If the Orion is visible in VictronConnect but greyed out, another device may be connected. For all other connection problems, please consult the VictronConnect manual for troubleshooting Bluetooth connection issues.