PanelScan Integration Guide Once in Run Mode, simply feed boards into the conveyor. The camera will trigger and capture, process the panel, and write the read data to disk. The resulting output string is shown in the lower left part of the user interface in the format in which it will be saved. The grid array is shown on the left in gray, green, or red. Gray means “untrained”. Green means that the symbol was successfully decoded. Red means that the symbol was not successfully decoded. You can click on any of these buttons and the system will zoom in to show that symbol. The decoded data is displayed in large bold letters in the text box below the buttons.
A pass / fail counter is visible at the bottom of the Run screen. This counter can be reset by clicking the Erase button. The vision job can be saved to disk and opened again to run at a later time. The job will be saved in the C:\PanelScan\Jobs directory. Note that when you save a job, two files are created: the .avp file, which is the job itself, and the .ini file, which contains all the PanelScan-specific job data. Because the layout of search windows is based on conveyor speed, it may be necessary to repeat the Teach process to ensure that regions of interest are centered on the barcode or Data Matrix areas when you open the job.
Fine Focus At this point you can run boards back and forth beneath the camera and finely adjust the camera’s focus. 19 Copyright © 2019 Omron Microscan Systems, Inc.