164 4-4 Starting and Driving When the vehicle has been started and the gear is in a driving gear like "D" or "R", engage EPB manually, then simply depress the accelerator pedal slowly to a certain degree. EPB is released automatically, with the indicator going off and the message "EPB Released" displayed. Warning Whenever possible, refrain from using for forced braking. Use the emergency braking function only extreme cases, for example, when the brake pedal fails or is blocked. This is because EPB cannot exceed the physical limit of road adhesion.
If the emergency braking function is used in curves, dangerous or congested roads, or in bad weather conditions, the vehicle may drift, skid or deviate. Release Failure If manual EPB release fails, press and hold the EPB switch for over 2 seconds. If EPB can be released, drive the vehicle to the nearest repair shop to check the brake pedal switch signal and relevant parts and lines. If it cannot be released, contact a BYD authorized dealer or service provider immediately. Emergency Braking When Brake Pedal Fails When the vehicle is running and ESC system works properly, if the brake is stuck or fails, controller deceleration parking (CDP) can be used.
If only EPB is engaged, the braking deceleration is 0.4 g; if EPB is engaged with the brake pedal pressed at the same time, the braking deceleration is 0.8 g. Avoid using EPB for forced braking, but only activate the emergency braking function in case of emergencies such as brake pedal failure or stuck brake pedal.