BYD Han — Adaptive Cruise Control (ACC) System

174 4-5 Driving Assistance Functions If the vehicle stops for more than 3 minutes, the ACC system enters standby mode, with EPB engaged. System Limitations The radar is installed at the front area of the vehicle. Blockage of its detection area by contaminants can disturb the intended function. In particular, if the sensor is covered by snow completely, the ACC system exits and notifies so through HMI. System function will recover after blockage is removed and the vehicle is restarted or runs for a while. The radar may have a transient function failure from limited detection if the vehicle runs under special conditions, such as circular ramps or tunnels.

The function may be recovered by restarting the vehicle or driving under normal conditions for a while. Reaching or leaving a curve may delay or disturb target selection. In such cases, the ACC vehicle may not brake as expected or may brake late. On roads with sharp curves, such as winding roads, the vehicle ahead may be out of ACC sensor detection for several seconds due to sensor vision limitations, possibly causing the ACC vehicle to accelerate automatically. Traffic flow and weather conditions - such as rain and fog - must be heeded for setting vehicle distance on the ACC system.

After the ACC system is properly set, the driver must be able to decelerate until the vehicle stops at any time. The ACC system may not be able to identify stationary or slow-moving objects, such as vehicles, the end of traffic, toll booths, bicycles, or pedestrians. This means a risk of collision and requires the driver to beware of the surroundings. The ACC system cannot identify pedestrians or oncoming vehicles. The ACC system can only achieve limited braking instead of emergency braking.