BYD Han — Adaptive Cruise Control (ACC) System

4-5 Driving Assistance Functions 173 ACC reset When the ACC system is in standby within the same ignition cycle, the system memorizes the last speed setting. Push up the lever ④ to restore to the stored speed prior to exiting the cruise system last time. Increasing/Decreasing target speed When ACC is active, set vehicle to a speed within the 30~150 km/h range by moving the lever ④ . Toggling the lever ④ up or down increases or decreases target speed by 5 km/h. ACC exit While ACC is active, pressing button ① for a second time or pressing the brake pedal makes the ACC system go on standby. Setting vehicle distance The driver must select a safe vehicle distance.

The system adjusts vehicle speed to keep a suitable distance from the vehicle ahead on the same lane. Pressing buttons ② and ③ on the steering wheel adjusts vehicle distance to any of the four available levels. At each level, vehicle distance is in direct proportion to vehicle speed. The faster the speed, the longer the distance. 4 Using and Driving Increasing/Decreasing speed with ACC active When ACC is activated, the driver can press the accelerator pedal to reach the set target cruise speed in advance. The system then enters over speed mode.

If the vehicle is already running at the target speed and the driver presses the accelerator pedal without performing any other operations, the vehicle will return to the target speed after the accelerator pedal is released. If the driver presses the brake pedal to slow down continuously, ACC goes into standby mode. After the brake is released, ACC will need to be reactivated. Follow-to-stop/start Controlled by ACC, the vehicle can stop when the vehicle ahead stops in normal driving conditions and resume driving automatically following the vehicle ahead if the stop is less than 30 seconds.

If the vehicle stops for less than 3 minutes, the driver needs to reactivate ACC by pressing the accelerator pedal or pushing up lever ④ .