198 4-5 Driving Assistance Functions The driver should ensure the normal operation of the BSD system, keeping the BSD radar sensors in good condition. For example, if they are covered in dirt, snow or other obstructions, they need to be cleared right away. If unrelated targets at the rear side or in the rear (such as large roadside barriers used during road repair, large billboards by the road, reflectors in tunnels, or other objects with a large reflection cross-sectional area) are wrongly selected as target vehicles, the BSD system will give an alert.
System Limitations Under some circumstances, it will be difficult for the system to assist the driver, and detection may be affected or delayed. Possible circumstances include, but are not limited to: Sudden lane change of a vehicle coming from the rear; Sharp turns, slopes and other settings where vehicles coming from behind are detected too late; Obscured target vehicle; Too small curve radius, or when the vehicle enters or exits a curve; Severe weather, such as rain or snow. Radar coming off, loosely installed, or blocked; Certain metal guardrails or similar road conditions. Targets that may not be responded include but are not limited to:
Pedestrians and animals; Influence of vibration or collision on BSD radar sensor calibration can degrade system performance. In that case, you are recommended to contact a BYD authorized dealer or service provider. Targets in environments with electromagnetic interference. Warning Blind spot assist only serves as a driving assistance function, so the driver must be fully responsible for driving safety.