BYD Han — Tire Repair Device* Use

298 7-1 When Faults Occur If the inflator needs to be connected to a power source, plug the inflator into the 12V socket in the vehicle, start the vehicle, and switch on the inflator. The tire sealant is then filled through the inflator hose into the tire along with air. Tip Make sure the inflator switch is off when plugging the power supply into the 12V socket in the vehicle. The inflator can only be turned on for up to 10 minutes. Observe the tire pressure gauge reading on the inflator. If the tire pressure does not reach 180 kPa (1.8 bar) within 10 minutes (red area shown in the figure), turn off the inflator. You are recommended to contact a BYD authorized dealer or service provider.

If the tire pressure reaches between 180 and 320 kPa (between 1.8 and 3.2 bar) (green and yellow areas shown in the figure), remove the kit as soon as possible and drive at a speed below 80 km/h within 1 minute, with the furthest driving distance not exceeding 10 km, so that the tire sealant is evenly distributed within the tire.