Super Micro Computer, Inc. PDSG4/PDSGE — Super Micro PDSG4/PDSGE User & Service Manual PDF

Chapter 3: Troubleshooting Chapter 3 Troubleshooting 3-1 Troubleshooting Procedures Use the following procedures to troubleshoot your system. If you have followed all of the procedures below and still need assistance, refer to the ‘Technical Support Procedures’ and/or ‘Returning Merchandise for Service’ section(s) in this chapter. Always disconnect the AC power cord before adding, changing or installing any hardware components. Before Power On 1. Make sure that the +5v standby LED is not lit (LE Indicators on the mother- board). 2. Make sure that the 8-pin 12v power connector at JPW2 is connected to your power supply. 3.

Make sure that there are no short circuits between the motherboard and chas- sis. 4. Disconnect all ribbon/wire cables from the motherboard, including those for the keyboard and mouse. 5. Remove all add-on cards. 6. Install a CPU and heatsink (Be sure that it is fully seated,) and then, connect the chassis speaker and the power LED to the motherboard. Check all jumper settings as well. 7. It is imperative that you use the correct type of CMOS battery as specifi ed by the Manufacturer. Do not install the CMOS battery upside down to avoid pos- sible explosion. No Power 1. Make sure that there are no short circuits between the motherboard and the chassis. 2.

Make sure that all jumpers are set to their default positions. 3. Check if the 115V/230V switch on the power supply is properly set. 4. Turn the power switch on and off to test the system. 5. The battery on your motherboard may be old. Check to verify that it still supplies ~3VDC. If it does not, replace it with a new one. No Video 1. If the power is on, but you have no video--in this case, you will need to remove 2. Use the speaker to determine if any beep codes exist. (Refer to Appendix A for all the add-on cards and cables fi rst. details on beep codes.) 3-1