PDSG4/PDSGE User's Manual cally reboot. If you choose the .exe fi le, please run the .exe fi le under Windows to create the BIOS fl ash fl oppy disk. Insert the fl oppy disk into the system you wish to fl ash the BIOS. Then, bootup the system to the fl oppy disk. The BIOS utility will automatically fl ash the BIOS without any prompts. Please note that this process may take a few minutes to complete. Do not be concerned if the screen is paused for a few minutes. ( * Warning : Do not shut down or reset the system while updating BIOS to prevent possible system boot failure!) Question: What's on the CD that came with my motherboard? Answer:
The supplied compact disc has quite a few drivers and programs that will greatly enhance your system. We recommend that you review the CD and install the applications you need. Applications on the CD include chipset drivers for the Windows OS, security and audio drivers. Question: Why can't I turn off the power using the momentary power on/off switch? Answer: The instant power off function is controlled in the BIOS by the Power But- ton Mode setting. When the On/Off feature is enabled, the motherboard will have instant off capabilities as long as the BIOS has control of the system.
When the Standby or Suspend feature is enabled or when the BIOS is not in control such as during memory count (the fi rst screen that appears when the system is turned on), the momentary on/off switch must be held for more than four seconds to shut down the system. This feature is required to implement the ACPI features on the motherboard. Question: How do I utilize the six-channel sound? Answer: The six-channel sound available on the PDSG4/PDSGE can be enabled with the audio driver software that was included in your motherboard package. When activated, sound will be routed through the jacks under the Game Port as follows:
Line Out = front L&R speakers, Line In = rear L&R speakers, MIC = center and subwoofer speakers. You must also enable the "AC97 Audio" setting in the Advanced Chipset section of the BIOS setup. Question: I installed my microphone correctly but I can't record any sound. What should I do? Answer: Go to , , , and then . Under the Properties tab, scroll down the list of devices in the menu and check the box beside "Microphone". Question: How do I connect the ATA100/66 cable to my IDE device(s)? Answer: The 80-wire/40-pin high-density ATA100/66 IDE cable that came with your system has two connectors to support two drives. This special cable must be 3-4