Super Micro Computer, Inc. PDSMA+ / PDSMA-E+ — Super Micro PDSMA+ / PDSMA-E+ User Manual: Motherboard Guide PDF

PDSMA+/PDSMA-E+ User's Manual 2-4 Installing DDR2 Memory Memory Module Installation (See Figure 2-2) Exercise extreme care when installing or removing memory modules to prevent any possible damage. 1. Insert each DDR2 memory module vertically into its slot. Pay attention to the notch along the bottom of the module to prevent inserting the module incor- rectly. (See support information below.) 2. Gently press down on the memory module until it snaps into place. Support The PDSMA+/PDSMA-E+ supports Dual channel, ECC/Non-ECC unbuffered DDR2 667/533/400 SDRAM. Both interleaved and non-interleaved memory are supported, so you may populate any number of DIMM slots.

(Populat- ing DIMM#1A,DIMM#1B, and/or DIMM#2A,DIMM#2B with memory modules of the same size and of the same type will result in dual channel, two-way interleaved memory which is faster than the single channel, non-interleaved memory. When ECC memory is used, it may take 25-40 seconds for the VGA to display.) *Notes : 1. Due to chipset limitation, 8GB Memory can only be supported by the following operating systems: 32-Bit: Windows 2000 Advanced Server, Windows Server 2003 Enterprise Edition; 64-Bit: Windows Server 2003 Standard x64 Edition, Windows XP Professional x64 Edition, Windows Server 2003 Enterprise x64 Edition. 2.

You may install a maximum of 2GB DIMMs on each slot; however, only DDR2 533 MHz 2GB density modules are available for this configuration. 3. Some old-version of DDR2-667 may not match Intel's On-Die-Temperature re- quirement and will automatically down-grade to run @ 533 MHz, If this occurs, contact your memory vendor to check the ODT value. 4. Due to memory allocation to system devices, memory remaining available for operational use will be reduced when 4 GB of RAM is used. The reduction in memory availability is disproportional. (Refer to the Memory Availability Table below for details.) 2-6