Super Micro Computer, Inc. PDSMA+ / PDSMA-E+ — Super Micro PDSMA+ / PDSMA-E+ User Manual: Motherboard Guide PDF

Appendix D: Adaptec HostRAID Setup Guidelines Appendix D Adaptec HostRAID Setup Guidelines After all the hardware has been installed, you must first configure the Adaptec Embedded Serial ATA RAID before you install the Windows operating system. The necessary drivers are all included on the Supermicro bootable CDs that came packaged with your motherboard. *Note: The following section provides information on the Adaptec SATA RAID Driver based on the Intel ICH7R South Bridge Controller. Introduction to the Intel ICH7R I/O Controller Hub Located in the South Bridge of the Intel 3000/3010 Chipset, the ICH7R I/O Controller Hub provides the I/O subsystem with access to the rest of the system.

It supports 1-channel Ultra ATA/100 Bus Master IDE controller (PATA) and one Adaptec's Se- rial ATA (SATA) Host Controller, which support up to six Serial ATA drives, up to two RAID volumes and up to four drives in RAID Configurations.

(See the table below for details.) D-1 Raid Level Create Via When Appropriate RAID 0 Quick Init Creating a RAID 0 on new drives RAID 0 Migrate* Creating a RAID 0 from one new drive and one drive with data you wish to preserve RAID 1 Build* Any time you wish to create a RAID 1, but especially if you have data on one drive that you wish to preserve RAID 1, RAID 10 Clear Creating a RAID 1 or RAID 10 on new drives, or when you want to ensure that the array contains no data after creation. RAID 1, RAID 10 Quick Init Fastest way to create a RAID 1 or RAID 10 Appropriate when using new drives