PDSMA+/PDSMA-E+ User's Manual To configure the Adaptec SATA RAID for Operating Systems that support RAID functions (--Windows, Red Hat & SuSe, Linux) 1. Press the key during system bootup to enter the BIOS Setup Utility. Note : If this is the first time you power on the system, we recommend that you load the Optimized Default Settings. If you have already done so, please skip to Step 3. 2. Use the arrow keys to select the "Exit" Settings. Once in the "Exit" settings, Scroll down to select "Load Optimized Default Settings" and press the key. Select "OK" to confirm the selection. Press to load the BIOS default setting. 3. Use the arrow keys to select the "Main" section in BIOS. 4.
Scroll down to "SATA Control Mode" and press to select "Enhanced" 5. Scroll down to "SATA RAID Enabled" and press . Then, select "En- abled." 6. Scroll down to "ICH RAID Codebase" and select "Adaptec". Then press ter>. (*For Adaptec ICH RAID configurations: Change the setting from Intel to Adaptec.) 7. Scroll down to "Exit". Select "Exit Saving Changes" from the "Exit" menu. Press the key to save the changes and exit the BIOS. 8. Once you've exited the BIOS Utility, the system will reboot. 9. During the system bootup, press the and keys simultaneously to run the Intel RAID Configuration Utility when prompted by the following message: Press for Adaptec RAID Configuration Utility . D-2