Chapter 1: Introduction PDSMi Quick Reference Jumper Description Default Setting JBT1 CMOS Clear See Section 2-7 JI 2 C1/JI 2 C2 I 2 C (SMB) Bus to PCI slots (Open/Open: Disabled) JP3 Compact Flash Master/Slave Select (Closed: Master) JPF Power Force-On Open (Disabled) JPG1 VGA Enable Pins 1-2 (Enabled) JPL1/JPL2 Giga-bit LAN 1/2 Enable Open (Enabled) Connector Description 24-PIn ATX (JPW1) ATX 24-Pin Power Connector 8-Pin PWR (JPW2) 12V 8-pin Power Connector (Required) COM1(J31), COM2 COM Port 1 & COM 2 Header DIMM#1A,#2A,#1B,#2B Memory (DIMM) Slots (1 through 4) Fans 1-6 System Fan Headers (Fans 1-5), Fan6:
CPU Fan FP Control (JF1) Front Panel Control Header (*Note 2) Floppy Connector (J27) Floppy Disk Connector IDE-Primary (J3) IDE Primary Slot (Blue) (*Note 1) IDE-Compact Flash (J4) Compact Flash Card (White) (*Note 1) IPMI IPMI 2.0 Socket J9 Speaker Connector (Pins 3-4: Internal Buzzer Enable, Pins 1-4:
External Speaker Cable) JL1 Chassis Intrusion Header JLED PWR LED KB/MS(J28) PS/2 Keyboard/Mouse Connector LAN1/LAN2 (JLAN1/2) Ethernet RJ45 (Gigabit LAN) Port1/Port2 Connectors Printer (J30) Parallel Port (Printer) Header SATA 0-3 (I-SATA 0-3) 4 Intel SATA Headers Slot 1 PCI 32-bit/66 MHz Slot 6+SXB-E1 PCI-X 133 MHz+PCI-Exp.x8 (Signal:x8 via Riser Cards) Speaker Internal Buzzer USB1/2 (J15) Back Panel Universal Serial Bus Ports 1,2 USB3/4 (J45),USB5/6 (J46) Front Panel Accessible USB headers 3,4,5,6 VGA (JG1) VGA Connector WOL(WOL) Wake On LAN header WOR(JWOR) Wake On Ring header LED Indicator Description (*(Refer to Addendum A) LE 1 Onboard Standby PWR warning LED Indicator LE3/LE4 BIOS POST Code Indicators *Note 1 :
J4 (the white slot) is for Compact Flash Card only. Do not use it for other devices. If J4 is populated with a Compact Flash Card, J3 (the blue slot) can support a single device. For JP3 to work properly, you need to connect the Compact Flash Card PWR Cable to JWF1 fi rst. *Note 2 : See Pg.2-7 for pin defi nitions 1-5