PDSMi User's Manual 2-4 Installing DDR 2 Memory Memory Module Installation (See Figure 2-2) Exercise extreme care when installing or removing memory modules to prevent any possible damage. Support The PDSMi supports Dual channel, ECC unbuffered DDR 2 667/533/400 SDRAM. Both interleaved and non-interleaved memory are supported, so you may populate any number of DIMM slots. (Populating DIMM#1A,DIMM#1B, and/or DIMM#2A, DIMM#2B with memory modules of the same size and of the same type will result in dual channel, two-way interleaved memory which is faster than the single channel, non-interleaved memory. When ECC memory is used, it may take 25-40 seconds for the VGA to display.) *Notes : 1.
Due to chipset limitation, 8GB Memory can only be supported by the following operating systems: 32-Bit: Windows 2000 Advanced Server/2003 Enterprise; 64-Bit: Windows Server 2003 Standard/Enterprise/Windows XP Professional x64 Edition. 2. You may install a maximum of 2GB DIMMs on each slot; however, only DDR 2 533 MHz 2GB density modules are available for this confi guration. 3. Some old-version of DDR 2-667 may not match Intel's On-Die-Tempeature re- quirement and will automatically be down-graded to run @ 533 MHz, If this occurs, contact your memory vendor to check the ODT value. 4.
Due to memory allocation to system devices, memory remaining available for operational use will be reduced when 4 GB of RAM is used. The reduction in memory availability is disproportional. (Refer to the Memory Availability Table below for details. 2-6 Possible System Memory Allocation & Availability Note For Microsoft Windows users: Microsoft implemented a design change in Windows XP with Service Pack 2 (SP2) and Windows Vista. This change is specifi c to the Physical Address Extension (PAE) mode behavior which improves driver compat- ibility. For more information, please read the following article at Microsoft’s Knowledge Base website at: http://support.micro- soft.com/kb/888137.
System Device Size Physical Memory Remaining (-Available) (4 GB Total System Memory) Firmware Hub fl ash memory (System BIOS) 1 MB 3.99 Local APIC 4 KB 3.99 Area Reserved for the chipset 2 MB 3.99 I/O APIC (4 Kbytes) 4 KB 3.99 PCI Enumeration Area 1 256 MB 3.76 PCI Express (256 MB) 256 MB 3.51 PCI Enumeration Area 2 (if needed) -Aligned on 256-MB boundary- 512 MB 3.01 VGA Memory 16 MB 2.85 TSEG 1 MB 2.84 Memory available to OS and other applications 2.84