Chapter 2: Installation Figure 2-2. Installing DIMM into Slot To Install: Insert module verti- cally and press it down until it snaps into place. Pay atten- tion to the notch. DDR2 To Remove: Use your thumbs to gently push each release tab outward to release the DIMM from the slot. 2-5 I/O Port/Control Panel Connector Locations The I/O ports are color coded in conformance with the PC99 specifi cation to make setting up your system easier. See Figure 2-3 below for the colors and locations of the various IO ports. Mouse (Green) Figure 2-3.
I/O Port Locations and Defi nitions KB (Purple) COM1 USB 0/1 LAN 1/LAN2 VGA (Blue) (Green) Front Control Panel Ground NMI 19 20 JF1 contains header pins for various buttons X X and indicators that are normally located on Power LED Vcc a control panel at the front of the chassis. These connectors are designed specifi cally NIC2 LED Vcc for use with Supermicro server chassis. Refer NIC1 LED Vcc to Figure 2-4 for pin defi nitions. (*Note: For OH/Fan Fail LED Vcc Vcc the motherboard to work properly, please HDD LED X Vcc always refer to the following section for Front Control Panel pin defi nitions and Ground Reset Reset Button descriptions.) Ground PWR Power Button 2 1 Figure 2-4.
JF1 Header Pins 2-7 Top View Of DDR2 Slot