Chapter 2: Installation 2-7 Jumper Settings Explanation of Jumpers To modify the operation of the motherboard, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. See the motherboard layout pages for jumper locations. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. GLAN Enable/Disable JPL1 enables or disable GLAN 1 Port, and JPL2 enables or disable GLAN 2 Port on the motherboard. See the table on the right for jumper settings. The default setting is enabled. A.
GLAN1 Enable KB/MS J28 24-Pin ATX PWR JPW1 Fan6/CPU Fan B. GLAN2 Enable USB 1/2 J15 COM1 J31 Mukilteo E7230 JG1 VGA (North Bridge) GLAN1 DIMM 1A DIMM 1 GLAN2 DIMM 2A DIMM 2 JLED FP CTRL Fan5 DIMM 1B DIMM 2B DIMM 3 DIMM 4 JF1 LAN CTRL SXB -E1 PCI-Ex8 JI 2 C1 JI 2 C2 Slot6 PCI-X 133 MHz Fan3 Fan2 S UPER PDSMi REV 1.0 LAN JPL1 A BIOS PXH-V Battery JPF JWD CTRL JPL2 IPMI CTRL VGA Buzzer SATA3 WOL S I/O B L E 3 ICH7R SATA2 ® J30 Printer 2-19 GLAN 1/2 Enable Jumper Settings Jumper Setting Defi nition Open Enabled 2-3 Disabled JPW2 Pentium Dual Core CPU LGA 775 1 COM2 ot1PCI 32 Bit/33 MHz JL1 L J J27 Floppy J4 (*I CD oE mpact Flash Card only) J3 IDE (Primary) Fan4