PDSMi User's Manual CMOS Clear JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads to prevent the accidental clearing of CMOS. To clear CMOS, use a metal object such as a small screwdriver to touch both pads at the same time to short the connec- tion. Always remove the AC power cord from the system before clearing CMOS. Note: For an ATX power supply, you must completely shut down the system, remove the AC power cord and then short JBT1 to clear CMOS. Do not use the PW_ON connector to clear CMOS. SMBus to PCI/PCI-Exp. Slots Jumpers JI 2 C1, JI 2 C2 allow you to con- nect PCIX/PCI-E slots to the System Management Bus .
The default setting is "Open" to disable the connection. See the table on the right for jumper settings. KB/MS 24-Pin ATX PWR JPW1 Fan6/CPU Fan A. Clear CMOS B. JI 2 C1 USB 1/2 J15 J28 C.
JI 2 C2 COM1 E7230 VGA J31 Mukilteo JG1 (North Bridge) GLAN1 DIMM 1A DIMM 1 JLED GLAN2 Fan5 DIMM 1B DIMM 2A DIMM 2 DIMM 3 FP CTRL DIMM 2B DIMM 4 JF1 LAN CTRL B C SXB -E1 PCI-Ex8 JI 2 C1 JI 2 C2 Slot6 PCI-X 133 MHz Fan3 Fan2 S UPER PDSMi REV 1.0 LAN JPL1 BIOS PXH-V Battery JPF JWD CTRL JPL2 IPMI CTRL VGA Buzzer WOL L E 3 ICH7R SATA3 SATA2 ® S I/O J30 Printer 2-20 SMBus to PCI/PCI/Exp Jumper Settings Jumper Setting Defi nition Closed Enabled Open Disabled (*Default) JPW2 Pentium Dual Core CPU LGA 775 1 COM2 ot1PCI 32 Bit/33 MHz JL1 L J J27 J4IDE J3 Floppy (*Compact Flash Card only) IDE (Primary) Fan4