Chapter 2: Installation Watch Dog Enable JWD controls Watch Dog, a system monitor that takes action when a soft- ware application hangs. Closing Pins 1-2 will reset the system if a program hangs. Close Pins 2-3 to generate a non-maskable interrupt for the program that hangs. (This function requires soft- ware support). Watch Dog must also be enabled in BIOS. VGA Enable/Disable JPG1 enables or disables the VGA Connector on the motherboard. See the table on the right for jumper set- tings. The default setting is enabled. KB/MS J28 24-Pin ATX PWR JPW1 Fan6/CPU Fan 8-pin PWR Fan1 JPW2 A. Watch Dog Enable USB 1/2 J15 Pentium Dual B.
VGA Enable COM1 E7230 Core CPU LGA 775 VGA J31 Mukilteo JG1 (North Bridge) GLAN1 DIMM 1A DIMM 1 GLAN2 DIMM 2A DIMM 2 JLED FP CTRL Fan5 DIMM 1B DIMM 2B DIMM 3 DIMM 4 JF1 LAN SXB -E1 PCI-Ex8 Slot6 PCI-X 133 MHz Fan3 Fan2 CTRL JI 2 C1 JI 2 C2 Battery JPF JWD A S UPER PDSMi REV 1.0 LAN CTRL JPL1 VGA BIOS PXH-V WOL JPL2 IPMI CTRL Buzzer SATA3 ® S I/O L E 4 L E 3 ICH7R SATA2 B JPG1 Slot1 PCI 32 Bit/33 MHz COM2 J9 JBT1 USB3/4 USB5/6 JWF1 (South Bridge) LE1 JWOR JP3 SATA0 SATA1 J30 J27 IDE J4 J3 IDE (Primary) Printer Floppy (*Compact Flash Card only) JL1 Fan4 2-21 Watch Dog Jumper Settings (JWD) Jumper Setting Defi nition Pins 1-2 Reset Pins 2-3 NMI Open Disabled VGA Enable/Disable Jumper Settings Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled