Troubleshooting file:///D|/J/english/200p4/safety/saf_troub.htm (2 of 3) [8/28/03 4:32:11 PM] G Press the Auto button. G Display position is incorrect Adjust the image position using the Horizontal Position &/or Vertical Position in OSD Main Controls. G Check that the signal cable is properly Image vibrates on the screen connected to the graphics board or PC. Vertical flicker appears G Press the Auto button. G Eliminate the vertical bars using the Clock Adjustment of VIDEO NOISE in OSD Main Controls. Horizontal flicker appears G Press the Auto button. G Eliminate the horizontal bars using the Phase Adjustment of VIDEO NOISE in OSD Main Controls.
G Adjust the contrast and brightness on OSD Main Controls. (The backlight of the LCD monitor has a fixed life span. When the The screen is too bright or too dark screen becomes dark or begins to flicker, please contact your dealer. G If an image remains in the screen for an extended period of time, it may be imprinted An after-image appears in the screen and leave an after-image. This usually disappears after a few hours G This is characteristic of liquid crystal and is not caused by a malfunction or deterioration An after-image remains after the power of the liquid crystal. The after-image will has been turned off.
disappear after a given amount of time G The remaining dots are normal characteristic Green, red, blue, dark, and white dots of the liquid crystal used in today’s remains technology.