7 Install Channels 2 Press OK to start the installation. If you run [Autoprogram] when you have locked channels, a message appears asking to enter your PIN . Enter your PIN in order to complete the installation. If you have forgotten your PIN, reset it as described in Change your PIN on page 19. 3 Select [Antenna] or [Cable] and press OK . When [Antenna] is selected, the TV detects antenna signals. It searches for NTSC and ATSC channels available in your area. When [Cable] is selected, the TV detects signals supplied by cable. It searches for NTSC, ATSC, and QAM modulated channels available in your area.
The fi rst time you setup your TV, you are prompted to select a menu language and to install TV and digital radio channels (if available). This chapter provides instructions on how to reinstall and fi ne-tune channels. Select Your Menu Language 1 Press MENU on the remote control and select [LANGUAGE] . PICTURE SOUND Select your menu language. English PICTURE SOUND Autoprogram will rescan all channels. Auto programming will take up to 20 minutes to complete. Antenna Back SETUP Seleccione el idioma para el menъ. SETUP Cable FEATURES LANGUAGE Espacol FEATURES LANGUAGE Antenna Select your signal source. USB Sйlectionnez la langue du menu.
Franзais USB Cable Or ANT.IN 2 Select a language and press OK to confi rm your choice. 3 Press MENU to exit. *The illustration is discribed for 42PFL3704D. When autoprogramming is complete, the lowest memorized channel will be displayed. 4 Follow the on-screen instructions to complete the installation. Set Your Location to Home You can set the location of your TV to [Home] or [Retail] . Choosing Home gives you full fl exibility to change predefi ned settings for picture and sound. 1 Press MENU on the remote control and select [FEATURES] > [Location] . 2 Select [Home] and press OK to confi rm your choice. 3 Press MENU to exit.
Channel List The channels selected here can be skipped when selecting the channels using CH +/- . Those channels can still be selected with the Number buttons . 1 Press MENU on the remote control and select [SETUP] > [Channel List] . Automatically Install Channels Before you install channels, ensure that you are registered with your cable TV provider and that your equipment is correctly connected. 1 Press MENU on the remote control and select [SETUP] > [Autoprogram] . PICTURE Autoprogram SOUND SETUP Add Channels Channel List FEATURES Antenna LANGUAGE USB PICTURE Autoprogram SOUND SETUP Channel List Add Channels FEATURES Antenna LANGUAGE USB 24 EN