2 Press or to select the channel you want to remove, then press OK . 2 Press a number (1 to 135) to enter the number of the channel you want to add, then press OK . English 10 PICTURE SOUND DTV DTV 40.1 40.2 FEATURES SETUP Highlight channels for Ch Up/Down key selection. DTV 40.3 LANGUAGE PICTURE SOUND For analog channels, select a channel to be added using number keys. Add channels USB FEATURES SETUP Ch Select Watch/Skip Back BACK OK LANGUAGE For digital channels, you must perform Autoprogram function. The channel display for the removed channel darkens. You will not be able to select the channel again using CH +/- . To reactivate a removed channel, press or and press OK .
The registered channels are highlighted. When you remove a major channel, its minor channels are removed as well. USB Ch Change Back BACK 3 Press MENU to exit. Note Note The channel with the [DTV] indicated on the display is ATSC. Otherwise the channel is NTSC. If setup completes successfully, [Added to the channel list] is displayed. If external input is used, it is not possible to register the channel and [Unavailable] will be displayed on the TV screen. By pressing or , you can select the memorized channels only. 3 Press MENU to exit.
Add Channels Optimize the Signal Quality from Your Antenna This function lets you add the channels that were not added by the autoprogram due to the receptible condition at the initial setup. 1 Press MENU on the remote control and [SETUP] > [Add Channels] . You can optimize your signal quality by tuning in ATSC channels with weak signals, and adjusting the antenna. 1 Press MENU on the remote control and select [SETUP] > [Antenna] . 2 Press OK to confi rm your choice. 3 Press a number (1 to 135) or press CH+ or CH- to select the channel for which you want to check the digital signal strength. 4 Press MENU to exit.
PICTURE SOUND Channel List Autoprogram SETUP Add Channels FEATURES LANGUAGE Antenna USB EN 25