Polaris Phoenix 200 — Polaris Phoenix 200 Owner's Manual & Service Guide PDF

TROUBLESHOOTING Engine Stops or Loses Power 95 Possible Cause Solution Out of fuel Refuel, cycle key to ON position three times for 5 seconds each, then start Kinked or plugged fuel vent line Inspect and replace Water is present in fuel Replace with new fuel Overuse of choke Inspect, clean and/or replace spark plugs Fouled or defective spark plug(s) Inspect, clean and/or replace spark plug(s) Worn or defective spark plug wires See your dealer Incorrect spark plug gap or heat range Set gap to specs or replace plug Loose ignition connections Check all connections and tighten Low battery voltage Recharge the battery to 12.8 VDC Incorrect fuel Replace with fresh recommended fuel Clogged air filter Inspect and clean or replace Reverse speed limiter malfunction See your dealer Electronic throttle control malfunction See your dealer Other mechanical failure See your dealer Overheated engine Clean engine exterior; see your POLARIS dealer