Topdon — Phoenix XLink User Manual

3.30 A/C System Relearn/Initialization If the ECU or actuator of the vehicle air conditioner is replaced, or the memory of the ECU memory is lost, air conditioner initialization learning is needed. 3.31 Engine Power Balance Monitoring During the power stroke of each cylinder, the power balance monitors crankshaft acceleration to determine the relative power provided by each cylinder. 3.32 Gas Particulate Filter Regeneration After long-term use of the particle catcher, fuel consumption will increase, engine output power will decrease. At this time, the GPF needs to be replaced or regenerated.

3.33 HIGH VOLTAGE BATTERY (High Voltage Battery Diagnostics) For diagnosis and state information detection on high-voltage accumulator. 3.34 Intelligent Cruise Control System For replacement of intelligent cruise control system of vehicle and matching after repairing. 3.35 Motor Angle Calibration There is a deviation between the rotor position detected by the angle position sensor of the motor and the actual rotor magnetic field position, so it is necessary to calibrate the motor angle. 3.36 IMMO PROG (Optional) Anti-theft editor supports vehicle key chip read and write, EEPROM chip read and write, MCU chip read and write, engine ECU and transmission ECU EEPROM and FLASH read and write.

3.37 CODAGE ECU After performing the encoding function of some systems, the control unit needs to be reset. Sometimes bad driving habit data can also be eliminated by resetting the ECU. The ECU reset service can command the ECU to perform self-reset through diagnostic commands. There are many forms of reset, which are distinguished according to the sub-function parameters. The ECU may also be hard factory reset by disconnecting the battery. 3.38 FRM MATCHING The foot space module is referred to as FRM. It is composed of a circuit module with a CPU. Its main function is to control the doors, windows, headlights and communication system of the vehicle.

After matching, it is used to clear the short circuit fault of the light. Damage to the FRM module can occur when replacing the battery, if the start switch is not turned off, if the battery terminal is grounded, or other non-professional battery operations occur. The general result is that the CPU data on the circuit board is lost, and control of things such as light, doors, and windows fails. If the data is lost, the same set 28